#LOGITECH HARMONY FLIRC OPENELEC UPGRADE#
#LOGITECH HARMONY FLIRC OPENELEC SOFTWARE#

Behaviour remains exactly as described above. Harmony 900 configured with Panasonic TC-P65VT30 profileĮdit: I know there is a similar report ( ) but there was no follow-up in the last half year and it also mentions the problem being not consistently reproducible.Įdit 2: For testing I upgraded to fw_wake_v6.bin (255.7 10-02-2011) but it doesn't make any difference.

#LOGITECH HARMONY FLIRC OPENELEC UPGRADE#

To upgrade to the latest firmware, grab the latest download on the website. You can fire up the GUI to check the firmware version. But if you already own a Logitech Harmony, then add the Flirc USB to your NUC. Unfortunately, this product has been discontinued. Make sure you have the at least firmware version 2.6. From my point of view, the Logitech Harmony Elite Remote Control (Infrared) is still the ne plus ultra to control an entire home cinema. So working through the setup, openelec had.

#LOGITECH HARMONY FLIRC OPENELEC SOFTWARE#

Again, this is completely consistent and reproducible on my systems.Īdjusting the inter-key delay for the Harmony itself using the configuration software doesn't appear to change anything. Decem12:12 Follow The Harmony has a built in profile for XBMC that's been fine tuned to work perfectly with flirc. I use the dongle on an openelec raspberry pi installation and have the Flirc accessed via a harmony one remote. I've a Logitech Hamrony Elite remote that I use to control all of my other AV devices. Setting the interkey_delay to 0 results in exactly three events (two superfluous) occurring while setting it to 7 results in exactly five events (four superfluous). 1 Hello, I've LibreELEC 7.0.2 running on Wetek OpenELEC (Play) box. XMBC Flirc Logitech Harmony One+ Raspberry PI By SIN7, Augin Remote Controls. I also observe a very short delay between the first (desired) event and the subsequent (superfluous) events. Flirc with Logitech Harmony One+ and XMBC Flirc with Logitech Harmony One+ and XMBC.

But I consistently and reproducibly experience the problem that apparently Flirc emits multiple key events for a single key press on the remote.Įxample: pressing 1 on the remote results in three to five 1 appearing on the screen (terminal, editor, etc) and of course also in XBMC.

Setting up my new Flirc with a Harmony 900 remote worked fine, especially after reading the Harmony sticky thread. I use an Harmony 650 and a FLIRC receiver to control my computer.

Logitech harmony flirc openelec